Operation - Hendi 209523 Gebrauchsanweisung

Operation

• Place one or two suitable cookware at the centre
of the heating surface of the appliance at each
time. (See---> Suitable cooking equipment).
Note: Do not place empty cooking equipment or put
too close as this may damage the cooking equip-
ment and the appliance.
• Connect the power plug to a suitable electrical
supply outlet.
• Then, switch ON the appliance by rotating the
knob clockwise at the right rear side of the ap-
pliance. This is done to set the temperature also.
• The set temperature will also be shown on the
display at the lower right corner
• Rotate the knob anti-clockwise to the "0" posi-
tion to switch OFF the appliance until there is no
display shown.
EN
Error codes display
Error codes shown on the display
E 1
E 2
E 3
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning & storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
6
Note:
1) Important. Place one or two suitable cookware
at the centre of the heating surface at each time.
2) If the cooking equipment is removed, beep sound
will be heard continuously and the appliance will
be switched off in 30 seconds with no display.
Cooling fan will be operated for 1 minute more.
3) The appliance's surface is still hot even after the
appliance is switched off. Wait completely cool
down before touching or cleaning.
Possible cause
The temperature of the appliance is
too high
The temperature sensor is damaged.
Input supply voltage is too high or too
low.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
Possible solution
Clear all obstacles that around the
appliance. Unplug the appliance, re-
move the pan or pot, wait until the ap-
pliance is completely cool down.
Contact the supplier.
Make sure that the appliance is con-
nected to a suitable electrical power
supply.