Operation - Hendi 239698 Gebrauchsanweisung

Operation

• Put the plug in the socket.
• Set the pan of your choice on the cooking surface,
bearing the above-mentioned instructions in
mind. NOTE! Make sure that the pans are cover-
ing the indicated zones at all times during use in
order to prevent the appliance from getting dam-
aged. Do not leave your pan on the burner while
empty as this may lead to damage to your pans.
• Switch the appliance on by pressing the "ON/
OFF" and then the "ARROW UP" key. If your pan
is suitable for induction and has a bottom diam-
eter of 14 cm, at minimum, the appliance will go
into operation. You will recognise this from the
fact that the fan will go on and the display will
show a capacity position of "2000". NOTE! If the
appliance beeps after being switched on, the pan
you are using is not suitable for induction or the
appliance is defective. In case of any doubt, al-
ways contact the supplier of your pan!
• Once the appliance is operating and the display
indicates position "2000", you can programme
the appliance in one of the following two ways:
1. Capacity control: You can control the perfor-
mance of the appliance, just as for a gas cooker
via 17 positions ranging from 100W to 3500W.
The default position for the appliance is "2000".
2. Temperature control: you can set the tempera-
ture between 35°C and 240°C in 5°C increments.
Standard position for the appliance is 100°C. AT-
TENTION! The programmed temperature is that
of the glass plate and not the temperature in the
pan!
Error codes display
Error codes shown on the
display (5)
E01
E02
E03
Possible cause
The temperature of the appliance is too high
Cooling fan defective
The temperature of the cookware is too high.
Possibly, the cookware becomes empty and
appliance will shut down for protection.
The supply voltage is abnormal. (Supply volt-
age is too high or too low)
• If you choose capacity control, select "heating"
using the " Temp/heating" key. Now you can pro-
gramme the capacity required by means of the
arrow keys, 3500W being the highest and 100W
the lowest position.
• If you select temperature control, select "Temp"
using the "Temp/heating" key. Now you can pro-
gramme the required temperature by means of
the arrow keys between 35°C and 240°C in 5°C
intervals.
• After programming the capacity or temperature,
you can opt to programme the timer. This timer
switches the appliance off after the programmed
time has been reached. You do this by pressing
the "Timer" key after programming the capacity
or temperature, and selecting "Timer". You can
now set the desired time. The maximum pro-
grammable time is 180 minutes.
• Once you have reached the required result, you
can switch off the appliance by pressing the "ON/
OFF" key. The display will go off and the lights
next to "Power", "Temp" and "Timer" will go off.
• If you do not use the appliance for an extended
period, remove the plug from the wall-mounted
electrical socket and remove the pans from the
appliance.
NOTE! Allow the appliance to cool off before you
touch it. The glass plate is very hot after use.
Possible solution
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Contact the supplier.
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.
EN
7