Ravelli RBH 150 V Bedienungs- Und Wartungshandbuch Seite 220

Problem Causes
Remote control not associated
with the stove
Radio interference
No communication
Remote control firmware not
between the stove
compatible with stove firmware
and the remote
("LINK" message appears on
control
the display)
Communication component
of the card or remote control
faulty
Remote control battery low
The remote control
does not work
Faulty remote control
Temperature not set correctly
Remote control position not
optimal for detecting room
temperature
The stove always
works at maximum
Additional temperature probe
power
or external thermostat (if pres-
ent) faulty
Defective or broken remote
control
Lack of electricity
The stove does not
Fuse tripped following a fault
turn on
Clogged exhaust or smoke
duct.
Use and maintenance manual RBH 150 V - RBH 200 V
Possible remedies
Pair the remote control to the stove following
the instructions given here
Evaluate the presence of other radio devices
in the vicinity
Contact the technical assistance service to
update the remote control FIRMWARE
Replace electronic card or remote control
Replace battery or connection to the stove via
cable
Replace remote control
Set the remote control temperature again
Place the remote control in another location
Check probe or thermostat and replace if
necessary
Check the remote control and replace if nec-
essary
Check that the power plug is inserted and the
switch in the "I / ON" position.
Replace the fuse with one having the same
characteristics (5x20 mm T 3.15A)
Clean the smoke outlet and / or the smoke
duct
EN
Rev.2 15/07/2021
Pag.71
Alarm signal