Installation; Use - Vortice SCALDATUTTO EVO T Betriebsanleitung

ENGLISH
• Always keep the appliance in an upright position.
• When the appliance is not being used, turn it off and
disconnect the plug from the power supply.
• Before cleaning the appliance in any way, turn it off
and disconnect the plug from the power supply.
• Do not immerse the appliance in water.
• Do not insert anything into the appliance.
• Keep the appliance's intake and outlet grilles free
and uncovered.
• Do not cover the appliance, as this may result in
dangerous overheating.
• This appliance is not suited for rooms used in
zootechnics.
• The appliance is equipped with safety devices (reset
manually) which cuts out if the appliance itself starts
to overheat, so as to avoid any risk of damage. In
these cases, disconnect the plug, leave the
appliance to cool for approximately 10 min. and
lastly plug it back into the power socket. To avoid the
harmful effects of continual switching on and off, it is
necessary to remove the cause of the trouble (grilles
obstructed, appliance tipped over, fan jammed, etc).
CAUTION:
Units must not be powered by an external switch
device such as a timer or must be connected to a
circuit that is regularly powered or disconnected
from power utilities to avoid any danger of accidental
reset of the thermal breaker device.

Installation

The fan heater is equipped with a rotary support base
and must be positioned on a flat and stable surface.

Use

1
1. Control panel
2. Remote Control
3. Remote control receiving sensor
4. Decorative ring
5. Front Net
6. Handle
7. Back cover
8. Dust filter
9. Main switch
- Press the main switch (9) positioning it to "I", the LCD
display will light up and it will be possible to start
using the product.
- Referring to the control panel (1) and the remote
control (2), the following functions are available:
• POWER : press Power to decide whether to set the
power of the product to: LO/HI/AUTO
LO
: in this mode the product works at minimum
power
HI
: in this mode the product works at maximum
power
AUTO:
in this mode the default temperature is 24°C.
Temperature can be set between 5 and 32°C; when
ambient temperature is below the set one, the
product works at maximum speed while if ambient
temperature reaches the set one, the product
automatically switched off and the fan keeps working
for the next 30 seconds.
OSC
• : press this key to activate the oscillation
function, press it again to deactivate it.
2
3
4
6
5
7
8
9
9