Throttle Cable Adjustment - Husqvarna TXC 250 Bedienungsanleitungen

THROTTLE CABLE ADJUSTMENT

To check the correct adjustment of the throttle operate as fol-
lows:
- Remove rubber caps (1);
- by moving the opening cable (2) back and forth, check that
free play is 3 mm;
- by moving the closing cable (3) back and forth, check that
free play is 1 mm;
- if it does not happen, loosen the nut (4) and appropriately
turn the adjuster screw (5);
(loosen it to decrease clearance, tighten it to increase it);
- after adjustment block the nut (4).
WARNING*: Operation with damaged throt-
tle cable could result in an unsafe riding con-
dition.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine
in a closed area or in a confined area.
2
5
4
4
ADJUSTING THE IDLE
Adjust the carburetor with warm engine and with the throttle
control in closed position. Proceed as follows:
- turn the idle speed adjuster screw (1) located on the throttle
body on the right-hand side of the vehicle, until setting idle
speed to 1,950 RPM (turn clockwise to increase the speed and
counterclockwise to reduce it).
1
3
1
5
SPECIFICATIONS - OPERATION - MAINTENANCE EN - 27