Mounting The Compressed Air Hose; Operation; Inflation - Parkside PALP 20-Li B2 Originalbetriebsanleitung

2. Press the On/off switch (10).
The device turns on.
-> When the preconfigured
pressure is reached, the device
switches off automatically.
3. To start the device again, press
the On/off switch (10) twice.
Switching on the cordless
compressor, variant 2:
1. Press the On/off switch (10) di-
rectly.
- the display switches on,
- the device starts,
-> the device switches off auto-
matically when the preconfi-
gured pressure is reached.
2. To start the device again, press
the On/off switch (10) twice.
If your device does not start by
pressing the on/off switch (10),
either the on/off button (6) must be
pressed on the display (4), or the
on/off switch (10) needs to be pres-
sed twice.
Switching off the cordless
compressor:
1. Press the On/off switch (10)
once.
2. Press and hold the On/off button
(6) for 3 seconds.
The display (4) goes out. The
preconfigured pressure is saved.
The devices are not suitable for
long-term use. Operation for over
20 minutes can cause overheating
and damage to the devices. If the
device is overloaded, switch it off
immediately and only put it back
into operation when it has cooled
down.
Mounting the
compressed air hose
(only the cordless compressor)
1. Loosen the coupling nut (1) (not com-
pletely).
2. Insert the device connection (12c) of
the compressed air hose (12) into the
retainer.
3. Retighten the coupling nut (1).

Operation

Inflation

Cordless air pump
1. Remove the valve cap on the
inflatable item.
2. Place the desired valve adapter
(23) on the air exhaust opening
(18) of the cordless air pump.
3. Insert the valve adapter (23) into
the valve on the inflatable item.
4. Turn the device on (On/off
switch (20) to position "I").
5. Switch the device off (On/off
switch (20) to position "0") when
the desired filling volume has
been reached.
6. Remove the valve adapter (23).
7. Put the valve cap of the infla-
table item back on.
Cordless compressor
1. Remove the valve cap on the
inflatable item (if applicable).
2. Mount the compressed air hose
(12) (if applicable).
3. Open the locking lever (12a)
(if applicable).
4. Place the desired valve adapter/
ball needle (13/14/15/16) on
the valve connection (12b) of the
compressed air hose (12).
GB MT
43