Technical Data; Safety Instructions - Parkside PALP 20-Li B2 Originalbetriebsanleitung

Technical data

Cordless air pump ................PALP 20-Li B2
Nominal voltage U ..................... 20 V
Air volume ................................ 70 m
Weight (operationally ready)
.....................................approx. 0.85 kg
Sound pressure level
) ................. 72.27 dB(A), K
(L
pA
Sound power level (L
measured ........ 83.27 dB(A), K
Vibration (a ) ........1.63 m/s
h
Cordless compressor ..............PAK 20-Li B2
Nominal voltage U ...................... 20 V
Max. operating pressure 0.70 MPa (7 bar)
Max. rotational speed ...........16000 min
Total rated output
of all in-built motors .........................80W
Weight (operationally ready)
: ....................................approx. 1.03 kg
Sound pressure level
) ................... 75.2 dB(A), K
(L
pA
Sound power level (L
measured ..... 85.3 dB(A), K
guaranteed ........................... 88 dB(A)
Vibration (a ) .......1.75 m/s
h
Temperature...........................max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device can only be operated with the
following rechargeable batteries:
PAP 20 A1, PAP 20 A2, PAP 20 A3.
This type of battery may be charged
with the following chargers: PLG 20 A1,
PLG 20 A3, PDSLG 20 A1.
= 3 dB
pA
)
WA
= 3 dB
WA
, K= 1.5 m/s
2
= 3 dB
pA
)
WA
= 2.47 dB
WA
, K= 1.5 m/s
2
Charging
time (min.)
PAP 20 A1
PAP 20 A2
3 /h
PAP 20 A3
Levels of noise and vibration were determi-
ned according to the standards and regula-
tions in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specified total vibration value and the
-1
stated specified noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibrati-
2
ons as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Safety instructions

Ensure that the safety instructions
are observed when operating the
trimmer.
GB
PLG 20 A1 PLG 20 A3
PDSLG 20 A1
60
75
90
MT
30
30
60
37