Initial Operation; Removing/Inserting The Rechargeable Battery; Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery - Parkside PALP 20-Li B2 Originalbetriebsanleitung

GB MT
observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and char-
ger from the Parkside
X 20 V Team series. A
detailed description of
the charging process and
further information can
be found in the separate
operating instructions.

Initial Operation

Removing/inserting the
rechargeable battery
Ensure that the device is
switched off.
1. To remove the battery (24) from the
device, press the release button (25)
on the battery and pull the battery (24)
out.
2. To insert the battery (24), push the bat-
tery (24) along the guide rail into the
device. you will hear it click into place.
Checking the
charge status of the
rechargeable battery
The battery charge status indicator (24a)
signalises the state of charge of the battery
(24).
Press the button (24b) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
42
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (24) when
the red LED on the charge status
indicator (24a) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (24) when
the red LED on the charge status
indicator is on.
1. Remove the battery (24) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (24) in the charging
compartment of the battery charger
(26).
3. Plug the battery charger (26) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (26) from the
mains.
5. Remove the battery (24) from the char-
ger (26).

Switching on and off

Switching on the cordless
compressor, variant 1:
1. Press the On/off button (6) on
the display (4) to switch the
device on. The display (4) shows
the preconfigured pressure (see
"Changing the pressure setting").