Operation - Cameo ROOT PAR BATTERY Bedienungsanleitung

MIC
10
Microphone for music control mode.
TILT
11
Knurled screw for tilting when used as uplight. The twin mounting bracket can be removed for a
more subtle look.
RUBBER FEET
12
Four rubber feet for stability.
SAFETY EYEBOLT
13
Safety eyebolt for securing the spotlight on crossbeam installations.

OPERATION

NOTES
• After the spotlight is switched on, "Welcome to Cameo," the model name, and the software ver-
sion are shown one after the other on the display during the start-up process. Once the process
is complete, the spotlight is ready for use and resumes whichever mode was most recently
activated.
• Hold down the MENU button for approx. 2 seconds to directly access the main display from the
lower menu levels. If there is no input within approx. two minutes, the main display is automati-
cally activated. Briefly press MENU to go up one level in the submenus.
• Press MENU and ENTER at the same time to go directly to the last edited menu option.
• Starting from the main display, briefly press the  button to rotate the information in the
display 180°.
• To quickly change a value (e.g., DMX start address), hold down the or  button.
• If the internal battery is charged while the spotlight is switched off, the battery symbol
appears in the middle of the display and the charging status is shown by the corresponding
segment flashing. The flashing stops once the battery is fully charged.
MAIN DISPLAY DMX MODE
The DMX address and the currently configured DMX start address (e.g., 001) are shown on
the display. If the DMX Delay function is activated, the delay group and the delay time are also
displayed. The battery's charging status is shown in five segments in the upper-right corner of the
display. When the spotlight is operated with a supply voltage, the internal battery is charged at the
same time and a lightning symbol appears next to the battery symbol.
11