Operation; Cleaning And Maintenance - EUROM Ceiling Fan 48 Anleitungsbroschüre

Once installation is completed, you can switch the power back on with the main switch.
Your ceiling fan is now ready for use.

OPERATION

Check that you have complied with all safety regulations; you can then switch on the
device by turning the operating button clockwise from OFF to HI. The fan will start to rotate
at the highest setting. By turning further, to MED or LOW, you will slow the fan down. In
order to switch the fan off, turn the button clockwise to OFF.

CLEANING AND MAINTENANCE

Switch the fan off in order to clean it. The fan only needs general, exterior maintenance.
Dust it regularly with a soft cloth or duster or use a vacuum cleaner with a soft brush to
clean. If it becomes very dirty, clean with a slightly damp cloth and a mild household
cleaning product. Dry everything thoroughly and allow the fan to dry properly before using
again. Ensure that water does not come into contact with anything other than the casing
and the turbines! Never rinse or spray the fan!
In order to prevent material discolouration or deformities, never use aggressive or
corrosive (cleaning) products.
Repairs must be carried out by qualified engineers. This also applies to repairs to the
electrical elements. Make sure that the power is always switched off via the main switch.
Please request original parts if the device needs to be repaired. Never open up the device
yourself!
If the device is subjected to modifications or repairs are carried out by unqualified persons,
the guarantees from the supplier, importer and manufacturer will become null and void.
CE - DECLARATION
Euromac bv. Kokosstraat 20, 8281 JC Genemuiden hereby declares that the ceiling fan,
brand EUROM, type Ceiling Fan 48, complies with the requirements of the Low Voltage
Directives 2006/95/CE and EMC 2004/108/CE and fulfils the requirements below:
EN60335-:2002+A1:04+A11:04+A12:06
+A2:06+A13:08+A14:10
EN 60335-2-80:2003+A1:04+A2:09
EN 62233:2008
EN 60598-1:2008+A11:09
EN 60598-2-1:1989
Genemuiden, 04-01-2014
W.J. Bakker, Gen. dir..
10
EN 55014-1:2006+A1:09
EN 55014-2:1997+A1:01+A2:08
EN 55015:2006+A1:07+A2:09
EN 61547:2009
EN 61000-3-2:2006+A1:09+A2:09
EN 61000-3-3:2008