Installation - EUROM Ceiling Fan 48 Anleitungsbroschüre

DIAGRAM OF COMPONENTS
1. = motor casing
2. = fan turbine
3. = connection bracket
4. = upper protective cap
5. = operating unit
DESCRIPTION
The Ceiling Fan 48 is intended to provide a refreshing flow of air in the relevant room. It
has been designed to be connected to an electrical point in the ceiling. It is operated using
a special, wall-mounted operating unit that is connected to the connection point in the
ceiling.
This wall-mounted contact unit enables the fan to be set to 3 different settings (LOW –
MED - HI) and switched off (OFF).

INSTALLATION

Before beginning to install the fan and/or the operating unit, the electrical installation must
be adequately prepared.
Choose the location on the ceiling where you would like to hang the fan. At this location,
there must be an electrical connection point (220-240V / 50HZ) with the correct cabling
that is connected to the wall-mounted unit in order to operate the fan. This connection
point must only be installed by an approved electrician. The ceiling must also be:
- At least 266cm above the floor.
- Made of material that is suitable and sturdy enough to bear the fan (also during use),
i.e. concrete, wooden beams or similar but not plaster, soft boards, scrap etc. able to
bear at least 100kg.
Ceiling fan
Your ceiling fan should be installed by someone with an understanding of electrical
cabling.
 Disconnect the power.
8