Interrupting Operation; Bleeding; Ending Operation - Parkside Performance PHDP 180 A1 Originalbetriebsanleitung

The motor starts briefly to build pres-
sure. Once the necessary pressure has
been built, the motor stops.
6. WARNING! Be aware of the re-
coil force when the water jet commen-
ces. There is a risk of injuring yourself
or other people. Ensure that your foo-
ting is secure. Keep a good hold on the
pistol grip (1).
Press the switch lever (17) on the pistol
grip (1).
The nozzle starts working at pressure
and the motor starts. If you release the
switch lever (17), the motor stops. The
high pressure is maintained in the sys-
tem.

Interrupting operation

1. Release the switch lever (17) on the
pistol grip (1).
2. If you put down the pistol grip: Lock the
switch lever using the child safety lock
(18) (seen from behind).
←
The switch lever is locked
→
You can pull the switch lever
WARNING! Risk of injury due to
pressure jet! Lock the switch lever every
time you take a break.
3. When taking longer breaks: Move the
on/off switch (30) to the "O" (OFF) po-
sition.

Bleeding

Bleeding the supply hose
1. Turn off the tap.
2. Remove the supply hose from the de-
vice.
3. For more information , see "Connecting
the water supply".
Bleeding the device
1. Move the on/off switch (30) into positi-
on "I" (ON).
2. Wait until pressure has built up and the
motor stops.
3. Move the on/off switch (30) to the "O"
(OFF) position.
4. Press the switch lever (17) on the pistol
grip (1) until the pressure has been re-
leased.
5. Repeat these steps a few times until the-
re is no more air in the device.

Ending operation

1. After working with cleaning agents:
- Empty the cleaning agent tank
- Rinse the device with clear water
until the lines are free of cleaning
agent.
2. Release the switch lever (17) on the
pistol grip (1).
3. Move the on/off switch (30) to the "O"
(OFF) position.
4. Turn off the tap.
5. Press the switch lever on the pistol grip
until the pressure has been released.
6. Unplug the mains plug and wind up the
mains connection cable (10).
7. Disconnect the device from the water
supply.
GB MT
53