PeakTech 1640 Bedienungsanleitung Seite 24


Use the device only for the purpose of its determination and
pay particular attention to warning notices on the device
and information on the maximum input values.
Electric safety:

Voltages over 25 VAC or 60 VDC are generally considered
dangerous voltages.

Only work on dangerous voltages by or under the
supervision of qualified personnel.

When working on dangerous voltages, wear suitable
protective equipment and observe the relevant safety rules.

Do not exceed the maximum permissible input values
under any circumstances (risk of serious injury and / or
destruction of the device)


Current measurements are always carried out in series with
the consumer, i.e. with the supply line disconnected.

Remove the test probes from the measurement object
before changing the measuring function.

Never touch the bare test probes during the measurement,
only hold the test leads by the handle behind the finger
guard. If applicable, discharge any capacitors before
measuring the circuit to be measured.
Measurement environment:

Avoid any
substances, gases and dust. An electric spark could lead to
an explosion or deflagration - danger to life!

Do not carry out measurements in corrosive environments,
the device could be damaged or contact points inside and
outside the device could corrode.

Avoid working in environments with high interference
frequencies, high-energy circuits or strong magnetic fields,
as these can negatively affect the device.

Avoid storage and use in extremely cold, humid or hot
environments, as well as long-term exposure to direct
sunlight.

Only use devices in damp or dusty environments in
accordance with their IP protection class.
proximity to
24
explosive and flammable