Maintenance - Carrier 40VL0058-7E-QEE Installations- Und Benutzerhandbuch

Maintenance

Cleaning of the unit
Turn off the power switch
Remove the air inlet grill
First switch off the power supply, take off the screw cap, and loosen the screw using a cross screwdriver.
Cleaning the Filter
• Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special
cookware detergent on the air inlet grid, and then clean it with
water after 10 minutes.
(A) remove dust with a vacuum cleaner.
(B) for excessive dust, use a soft-hair brush and a mild detergent
to clean.
(C) Allow filter to dry fully before reinstalling.
• Do not clean with hot water of over 50°C to avoid fading or distortion.
• Do not dry on the fire, or the cleaner might cause fire.
Clean the indoor(outdoor) unit
Clean the unit using a cloth dipped in warm water or a neutral detergent, and subsequently wipe away the
moisture using a dry cloth.
Do not touch the unit with wet hands
Attention
7
Do not clean the unit using
hot water or any solvents