Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Procedures
• Fix the wall board to the wall using four screws As shown in the figure .
• Remove the front panel; then use two fastening screws to fix the unit on the floor as shown in the figure.
• Once refrigerant piping and drain piping connections are complete, fill the gap in the hole using putty. Attach the
front panel and front grille in their original positions, once all connections are complete.
REFRIGERANT PIPING
13
Werbung
Kapitel
Inhaltsverzeichnis
