Preparing The Machine For Work; Working - Tennant T191 Bedienungsanleitung

Preparing the machine for work

Before starting work, wear overalls, ear protectors, non-slip waterproof shoes, mask to protect the
respiratory tract, gloves and all other personal protection devices recommended by the supplier of the
Proceed as follows before starting work.
battery powered versions: check the battery charge (charge if necessary);
via the opening at the front,
water and low-foam detergent. Leave at least 5 cm between the surface of the liquid and the opening of water and low-foam detergent. Leave at least 5 cm between the surface of the liquid and the opening of
the tank; the tank;
make sure that the squeegee is securely fastened and connected to the suction hose; check that the make sure that the squeegee is securely fastened and connected to the suction hose; check that the
front and rear blades are not worn. front and rear blades are not worn.
adjust the working height of the squeegees. adjust the working height of the squeegees.
prepare the work area by removing all possible obstacles;
begin working from the furthermost point to avoid walking on the area you have just cleaned;
choose the straightest possible working routes;

Working

After setting up the machine, proceed as follows:
Connect the machine as follows:
mains powered versions: plug the machine into the mains power socket and press the main
trols - Descriptions");
check regularly that detergent is reaching the brushes and top up if necessary;
trips, stop work and empty the tank.
a few seconds, the brush and suction motor shut down to prevent draining the batteries excessively. a few seconds, the brush and suction motor shut down to prevent draining the batteries excessively.
Charge the batteries. Charge the batteries.
detergent used or necessitated by the work environment.
IMPORTANT! IMPORTANT!
WARNING
follow a few simple rules:
WARNING
EN
-
After After
26