Movement Installation; Lifting And Transporting The Packaged Machine; Delivery Checks; Unpacking - Tennant T191 Bedienungsanleitung

Lifting and transporting the packaged machine

Always load/unload lorries in adequately illuminated areas.
The machine is packaged on a wooden pallet by the Manufacturer. It must be loaded on to the transporting vehicle
using suitable equipment (see EC Directive 89/392 and subsequent amendments and/or additions). At destina-
tion, it must be unloaded using similar means.
A fork lift truck must always be used to lift the packaged body of the machine. Handle with care to avoid knocking
or overturning the machine.

Delivery checks

When the carrier delivers the machine, make sure the packaging and machine are both whole and undamaged. If
the machine is damaged, make sure the carrier is aware of the damage and before accepting the goods, reserve
the right (in writing) to request compensation for the damage.

Unpacking

When unpacking the machine, the operator must be provided with the necessary personal protection
Proceed as follows to unpack the machine.
cut and remove the plastic straps using scissors or nippers;
open the packaging;
remove the bags included in the packaging and check the contents:
User manual;
Battery charger operator manual.
Wall Chart.
Battery bridge with fuse (battery model only);
Battery charger power cable extension with SCHUKO plug (battery version);
Battery charger power cable extension with UK plug (battery version);
clean the outside of the machine in respect of safety regulations; clean the outside of the machine in respect of safety regulations;
after unpacking the machine, install the batteries (battery versions) or connect the electrical connec- after unpacking the machine, install the batteries (battery versions) or connect the electrical connec-
tions (mains powered versions). See relevant sections. tions (
The packaging may be kept and reused to protect the machine if it is moved to another site or to a repair work-
shop.
Otherwise it must be disposed of in compliance with current legislation.

Electrical connections and earth (mains powered versions)

The electrical characteristics of the machine are given on the rating plate. Make sure the frequency and voltage
correspond to those of the mains supply where the machine will be operated. As far as voltage is concerned,
V. Similarly, models rated at 115 V can be used between 110 V and 120 V. To avoid the risk of electrocution, only
Do not use an adapter with this machine.
The frequency on the plate must always correspond to the mains voltage.

MOVEMENT INSTALLATION

WARNING
being accidentally dropped.
WARNING
devices (gloves, goggles, etc.) to limit the risk of injury.
EN 21