CMS Brembana Maxima 309 Installations- Betriebs Und Wartungshandbuch Seite 206

TLV of solvent mixture: 491 mg/m3
8.2 Exposure controls
As the use of adequate technical equipment must always take priority over personal protection equipment, make
sure that the workplace is well aired through effective local aspiration or bad air vent. If such operations do not
make it possible to keep the concentration of the product below the permitted workplace exposure thresholds a
suitable respiratory tract protection must be used. See product label for hazard details during use. Ask your
chemical substance suppliers for advice when choosing personal protection equipment. Personal protection
equipment must comply with the rules in force indicated below.
HAND PROTECTION
Protect hands with category I (ref. Directive 89/686/EEC and standard EN 374) work gloves, such as those in latex,
PVC or equivalent. The following should be considered when choosing work glove material: degradation, breakage
times and permeation. Work glove resistance to preparations should be checked before use, as it can be
unpredictable. Gloves' limit depends on the duration of exposure.
EYE PROTECTION
Use of protective airtight goggles (ref. standard EN 166) recommended.
SKIN PROTECTION
Wear category I professional long-sleeved overalls and safety footwear (ref. Directive 89/686/CEE and standard
EN 344). Wash body with soap and water after removing overalls.
RESPIRATORY PROTECTION
If the threshold value for one or more of the substances present in the preparation for daily exposure in the
workplace or to a fraction established by the company's prevention and protection service is exceeded, wear an
FFP3 (ref. standard EN 141) type half mask.
The use of breathing protection equipment, such as masks with organic vapour and dust/mist cartridges, is
necessary in the absence of technical measures limiting worker exposure. The protection provided by masks is in
any case limited.
If the substance in question is odourless or its olfactory threshold is higher than the relative exposure limit and in
the event of an emergency, or when exposure levels are unknown or the concentration of oxygen in the workplace
is less than 17% volume, wear self-contained, open-circuit compressed air breathing apparatus (ref. standard EN
137) or fresh air hose breathing apparatus for use with full face mask, half mask or mouthpiece (ref. standard EN
138).
9. Physical and chemical properties
Colour
Odour
Appearance
Solubility
Viscosity
Vapour density
Evaporation Rate
Reactive Properties
Partition coefficient: n-octanol/water
Pressure at 20°C
pH
Boiling point
Flash point
Explosive properties
Vapour pressure
Specific gravity
VOC (Directive 1999/13/EC) :
VOC (volatile carbon) :
Soltecno S.r.l.
031-PTFE spray
transparent
characteristic of solvent
aerosol
insoluble in water, soluble in organic
solvents
Not available
> 1
Not available
Not available
Not available
4 bar
N.A.
<35°C
<0°C
Not available
Not available
0,600Kg/l
98,70 % - 592,20g/litre of
preparation
79,52 % - 477,10g/litre of
preparation
Revision nr. 4
Dated 08/02/2010
Printed on 25/03/2010
Page n.4 / 7