CMS Brembana Maxima 309 Installations- Betriebs Und Wartungshandbuch Seite 178

AGIP GREASE MU EP
AGIP GREASE MU EP are special yellow-brown, slightly-fibrous, smooth-textured lithium-base greases containing EP
(Extreme Pressure) additives.
The various grades differ only in consistency.
CHARACTERISTICS (TYPICAL FIGURES)
GREASE MU EP
NLGI consistency
Worked penetration
ASTM dropping point
Base oil viscosity at 40°C
PROPERTIES AND PERFORMANCE
The presence of EP (Extreme Pressure) additives ensures that AGIP GREASE MU EP greases form a tenaciously
adhering lubricating film which resists displacement even when subjected to heavy pulsating loads, thus preventing
metal-to-metal contact of the lubricated surfaces.
The multipurpose characteristics of AGIP GREASE MU EP greases facilitate lubrication planning and reduce the
range of stocks to be held.
Their good physical and chemical stability ensures that these greases remain unaltered even after long exposure
to high mechanical loads and thermal stresses, while their outstanding oxidation resistance inhibits deterioration
both during storage and use.
Their high dropping point allows the products to be used over a wide range of temperatures.
They ensure effective rust-protection even where the most delicate metals are concerned, and they adhere
extremely well to metal surfaces resisting displacement by vibrations.
AGIP GREASE MU EP greases are water-resistant and can be used in moist conditions and in contact with water,
while good pumpability facilitates dispensing even at low temperatures.
APPLICATIONS
AGIP GREASE MU EP are suitable for use in all cases where conditions call for a grease with EP (Extreme Pressure)
properties. For example, plain bearings, heavily loaded ball and roller bearings even when operating at high
temperatures, and for all lubrication requirements in general where operating conditions are especially difficult.
Their ability to withstand loads widens their range of application to embrace many fields of technology.
SPECIFICATIONS
AGIP GREASE MU EP meet the following classifications:
GREASE MU EP
DIN 51 825
DIN 51 826
AGIP GREASE MU EP 0, 1, 2 are approved by Danieli according to Standard 0.000.001 specification
Eni S.p.A.
Divisione Refining & Marketing
dmm
°C
mm
0
ISO L-X-BCHB 0
KP0K -20
G0K
Via Laurentina 449, 00142 Roma
Tel. centralino +39 06 5988.1
www.eni.it
0
0
370
180
2
/s 160
1 2
L-X-BCHB 1 L-X-BCHB 2
KP1K -20 KP2K -20
G1K -
1 2
1 2
325 280
185 185
160 160
3
L-X-BCHB 3
KP3K -20
-
[IN835.05.03]
Page 1 of 1
3
3
230
185
160