Working With The Cultivator; Placing The Front Wheel In The Operating Position; Adjusting The Blade Spur - Stihl MH 700 Gebrauchsanleitung

11 Working with the Cultivator

► Set the main switch to the 0 position.
The engine cuts out.
► If the engine does not cut out:
► Do not use the tiller and consult a STIHL specialist
dealer.
The main switch is defective.
Throttle lever
► Start the engine.
► Move the throttle lever.
The engine speed changes.
► If the engine speed does not change:
► Do not use the tiller and consult a STIHL specialist
dealer.
The throttle lever is defective.
Gear lever
► Engage gear 0/R, 1 and 2.
► If one of the gears cannot be engaged:
► Do not use the tiller and consult a STIHL specialist
dealer.
The gear lever is defective.
Light switch
► Start the engine.
► Press the On switch.
The headlamp comes on.
► Press the Off switch.
The headlamp goes off.
► If the headlamp does not come on:
► Check whether the headlamp is defective.
► If the headlamp is not working:
► Do not use the tiller and consult a STIHL specialist
dealer.
The light switch is defective.
0478-404-9604-A
11 Working with the Cultivator
11.1 Placing the Front Wheel in the Operating
Position
► Detach retaining pin (1) and remove pin (2).
► Fold up front wheel (3) so bores (4) align.
► Insert pin (2) through bores (4).
► Push retaining pin (1) through the bore in pin (2).
Pin (2) is secured and front wheel (3) is in the operating
position.

11.2 Adjusting the Blade Spur

The blade spur can be adjusted in eight stages.
► Place the front wheel in the operating position.
English
67