Malfunctions, Cause, Remedy; Malfunctions During Operation - Silvercrest MONSIEUR CUISINE ÉDITION PLUS SKMK 1200 A1 Bedienungsanleitung

16. Malfunctions, Cause, Remedy

16.1 Malfunctions during operation

Malfunction
Device does not start.
Liquid underneath the
device
Liquid escapes at the
lid 32 of the blender
jug 5
No temperature can be
set.
Parts of the device are
discoloured.
A speed setting ex-
ceeding 3 cannot be
selected.
Cause
Blender jug 5 is not posi-
tioned correctly
Lid 32 or deep steamer bas-
ket 3 have not been placed
correctly onto the blender
jug 5.
No power supply
The blade assembly 27 has
not been inserted correctly so
that the blender jug 5 is leak-
ing.
Seal 26 for the blade assem-
bly is defective.
Liquid escaped from the
blender jug 5 flowing onto
the surface through the over-
flow hole 10 of the base
unit 12. (see "Overflow" on
page 49)
Seal 31 has not been inserted
correctly.
Seal 31 is defective.
A speed setting 4 - 10 was se-
lected.
Certain food or spices (e.g.
curry) may discolour plastic.
This is not a defect with the de-
vice
A temperature has been set.
Remedy
Insert blender jug 5 correctly (see
"Insert blender jug" on page 51).
Place lid 32 or deep steamer bas-
ket 3 correctly.
Check mains plug 7, main
switch 6 and possibly the fuse.
Insert blade assembly 27 correctly
(see "Using and removing the
blade assembly" on page 50).
Insert new seal 26 (see "Clean-
ing, checking and replacing seals"
on page 59).
When mixing liquids at speed 10
or with button TURBO 18, the
blender jug 5 must not contain
more than 1 litre, since otherwise
liquid may be ejected. For speed
settings of less than 10, the blend-
er jug 5 may only be filled up to a
maximum of 2.2 litres.
Insert seal 31 correctly (see
"Cleaning, checking and replac-
ing seals" on page 59).
Insert new seal 31 (see "Clean-
ing, checking and replacing seals"
on page 59).
Select speed setting 0 - 3 (see "Set-
ting the speed" on page 48)
Remedy unnecessary, since not
harmful to health.
Set temperature to 0.
61
GB