Cleaning The Base Unit; Cleaning In The Dishwasher; Cleaning The Accessories; Cleaning, Checking And Replacing Seals - Silvercrest MONSIEUR CUISINE ÉDITION PLUS SKMK 1200 A1 Bedienungsanleitung

CAUTION:
Never use any abrasive, corrosive or
scratching cleaning agents. These might
damage the device.
NOTE:
• Certain food or spices (e.g. curry) may
discolour plastic. This is not a defect
with the device and harmless to health.

15.1 Cleaning the base unit

1. Clean the outside of the base unit 12
with a damp cloth. You can also use
some detergent.
2. Use clear water and wipe with a clean
cloth.
3. Do not use the base unit 12 until it is
completely dry again.
15.2 Cleaning in the dish-
washer
The following parts are dishwasher-safe:
- Blender jug 5
- Measuring beaker 33
- Lid for blender jug 32
- Seal for the lid of the blender jug 31
- Blade assembly 27
- Seal for blade assembly 26
- Cooking pot 28
- Mixer attachment 29
- Spatula 30
- Steamer basket, deep 3
- Seal of the deep steamer basket 4
- Steamer basket, shallow 2
- Lid for the steamer baskets 1
Never use a dishwasher to clean the fol-
lowing parts:
- Base unit 12

15.3 Cleaning the accessories

1. Rinse the blender jug 5 with warm wa-
ter and dump the water.
2. Remove the blade assembly 27 (see
"Using and removing the blade assem-
bly" on page 50) and take the seal 26
off (see "Cleaning, checking and re-
placing seals" on page 59).
3. Clean all accessories by hand in a sink
with dishwater or in the dishwasher.
4. When cleaning by hand, rinse all parts
with clean water.
5. Allow the parts to dry completely before
using them again.
6. Before using the device again, reinsert
the blade assembly 27.
15.4 Cleaning, checking and
replacing seals
Remove seals 26, 31 and 4 for cleaning
and check them for damage. Pay attention
to changes (e.g. porous material or tears).
- The removed seals 26, 31 and 4 can
be cleaned in the dishwasher.
- Damaged seals 26, 31 and 4 must be
replaced with new ones. You can reor-
der new seals (see "How to order acces-
sories" on page 63).
CAUTION:
Prior to the next use, damaged
seals 26, 31 and 4 must be inserted
again or replaced with new ones. An
operation without seals 26, 31 and 4
in place is not permitted.
Blade assembly
1. Remove the blade assembly 27 from
the blender jug 5 (see "Using and re-
moving the blade assembly" on
page 50).
2. Pull seal 26 off the blade assembly 27.
27
59
GB