Troubleshooting - Silvercrest SHBS 500 D4 Bedienungsanleitung

Troubleshooting

The following table will help you locate and correct any problems:
Fault
The appliance
will not switch
on.
The cutting blade
of the shaving
head 1 is
labouring/not
moving freely.
NOTE
► If you cannot solve the problem with the solutions given above,
please contact the Service Hotline (see section Service) .
SHBS 500 D4
Possible cause
The battery is empty.
The shaving head 1
is dirty and/or the
cutting blade is not
sufficiently oiled.
Remedy
Connect the appliance
to a mains power socket
(see section Charging the
appliance).
Clean the shaving head
1 and oil the cutting
blade (see section Clean-
ing the shaving head
and oiling the cutting
blade).
GB│MT
│
105 ■