Clatronic ar 815 Bedienungsanleitung Seite 67

Operation
This chapter gives important operating instructions for the unit.
NOTE
►
If no button is pressed for 5 seconds or no setting is made,
then the unit returns to the previous mode. Changed settings
are saved.
On/Off
‹
Press any button except
panel (2) to turn the unit on. The display is activated.
‹
Press (1) to turn the unit off.
Settings
Volume
WARNING
Hearing damage due to high volume!
High volumes can permanently damage your hearing.
►
Set a moderate volu me.
‹
Turn the multi control knob (3) to set the volume.
Sound Settings
‹
Press the multi control knob (1). The current volume is dis-
played. Press again to cycle through the next setting options.
The following settings are possible:
VOL - volume (0 to 100)
BAS - bass (-10 to +10)
TRB - treble (-10 to +10)
BAL - Balance (sound distribution between left and right speak-
ers) (10L to 10R)
FAD - Fader (sound distribution between rear and front speak-
ers) (10F to 10R)
‹
Turn the multi control knob to change the displayed setting.
Further Settings with the Multi Control Knob
‹
Press and hold the multi control knob (1) to access further
setting options.
‹
Turn the multi control knob to change the displayed setting.
(8) and unlock button for front
The following settings are possible:
BEEP
key tone:
■
BEEP 2ND : The unit sounds a beep tone when
you press and hold a multifunctional button.
■
BEEP ALL : The unit sounds a beep tone every
time you press a button.
■
BEEP OFF : The unit sounds no beep tone.
AREA Region, when the unit is used, Europe (EUR) or USA.
NOTE
►
Changing this setting deletes all station
presets.
TA Traffic announcements
■
TA SEEK
: With activated TA function the unit
searches for a station with traffic announce-
ments.
■
TA ALARM
: No automatic station search. The
unit sounds a beep tone if no traffic information
is received and NO TP/TA is displayed. SEEK
PI is displayed if the selected station does not
transmit an RDS signal.
PI Moving into an area where two stations with identical
AF, but different Pl code (PI = program information)
are received destabilizes reception. In this situation
you have two options:
■
PI SOUND
: To change stations the other station
is played for less than one second.
■
PI MUTE : The other station is muted.
RETUNE
Delay for automatic search with traffic announcements
and/or program information:
■
S (short) after approx. 30 seconds
■
L (long) after approx. 90 seconds
MASK
Setting to mask station during search:
■
DPI : Alternative frequencies with different Pl
code are excluded from the search.
■
ALL : Alternative frequencies with different Pl
code and no RDS information with high signal
level are excluded from the search.
67