Parts And Components; Before Use - cecotec READY WARM 8200 BLADELESS Bedienungsanleitung

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
Front
1. Housing
2. Outlet
3. Display
4. Base
5. Safety push button
Back
6. Filter
7. Power switch

2. BEFORE USE

Take the product out of the box and remove any packaging materials.
Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
Place the heater on a flat and stable surface.
Set the power-level switch at "0" and plug the product's cord into an earthed power supply.
Note: There may be a trace of odour during the first few minutes of initial use, or after a period
of storage. This is normal and will quickly disappear.
3. OPERATION
The device may be operated from the control panel or the remote control.
Power switch
Turn the device on and off from the power switch located on the back part of the unit.
Control panel
Fig. 2.
Oscillation
1.
2. Mode/On/off
3. Timer
4. Temperature
34
READY WARM 8200 BLADELESS/8400 BLADELESS CONNECTED
Oscillation button
Press the oscillation button to activate or deactivate the oscillation function. When it is
activated, the oscillation light indicator will turn on and air flow will be moved from left to right.
Mode/On/off button
Press once to turn the device on.
Press the button again to select one of the 3 operating modes: Fan, Low and High.
The corresponding light will turn on steady.
To turn the device off, press the button to set Fan mode, the corresponding light will start
flashing and the display will show a 30-second countdown.
When these 30 seconds are over, the heater will turn off.
Timer button
Press the timer button repeatedly to increase the operating time by 1-hour intervals. The timer
can be set from 1 to 12 hours.
The display will show the remaining operating time during a few seconds (blinking) and the
timer indicator will light up.
To cancel the timer, press the timer button repeatedly until 00 is displayed.
Temperature button
Press the temperature button repeatedly to increase the room temperature, from 15 to 0 ºC.
Once the temperature is set, the digits will flash for 3 seconds and then the display will show
the current room temperature.
Once the desired temperature is reached, the device will automatically switch mode.
The device features a safety push button on its vase, which turn the device automatically off
if tilted by accident.
Remote control
Fig. 3.
On/off
1.
2. Mode
3. Temperature increase
4. Timer
5. Temperature decrease
6. Oscillation
Replacing the batteries
Fig. 4.
The remote control is powered by a Lithium Button Cell Battery (CR2025). Should the remote
become unresponsive, replace the battery following the instructions below:
READY WARM 8200 BLADELESS/8400 BLADELESS CONNECTED
ENGLISH
35