Inhaltsverzeichnis
Werbung
GB
A3 Electrical seat connection with
external rocker switch
(inclination seat backrest)
(Figure C and D)
(only for Expert, Specialist, Speed and
Cross Speed)
The following parts are included with the seat:
1 cable harness (2) (already built into the seat)
-
with pre-assembled rocker switch (7)
1 circular tab (3) (ground connection)
-
1 tab receptacle (current connection)
-
1 fuse holder (4) with 2 spring contacts (5) and a
-
20A fuse
-
Warning!
Unintentional triggering of the side airbag
and/ or of belt tensioner !
In case of unintentional ignition of the belt
tensioner or of the side airbag it may happen
that parts fly around.
This can cause serious injury.
Before starting:
Take out the ignition key.
Disconnect the negative terminal at the
battery and wait for 20 minutes.
3.1 Fitting and connecting the external
rocker switch – Figure C
1.
Make a rectangular cut-out measuring 19 x 32
mm for the rocker switch (7) at a clearly visible
location, e.g. in the dashboard
2.
Connect the enclosed cable harness (2) to the
two-pole connector (1) on the seat.
3.
Bear in mind the adjustment travel of the seat
when laying the cables.
Ground connection (-):
4.
Fit the circular tab (3) to the end of the brown
cable (-).
5.
Connect this to a ground point on the car body.
3.2 Current connection (+) – Figure D
The red cable (+) must be connected to a terminal with
ignition current interruption. Depending on the type of
vehicle, select:
Version 1 – Connection A
Fuse location is available
In the fuse box, an unoccupied fuse holder with ignition
current interruption (e.g. terminal 15).
1.
Plug the red cable (+) onto the terminal of the fuse
holder with the tab receptacle.
2.
Insert a 20A fuse into the fuse holder.
A Electrical seat connections
Version 2 – Connection A
No
connection
A terminal with ignition current interruption on the non-
fused side in front of the fuse box.
In this case, the enclosed fuse holder (4) with the 20A
must be fitted in the red cable (+).
It this particularly important that you make sure that
the fuse holder is as close to the terminal as
possible and that it is easily accessible. Lay the
short, non-fused part of the supply cable with
particular care, so that no short circuit can arise
here.
1.
2.
Version 3 – Connection B
Connection via relais, not enough cable cross
section
interruption available
1.
2.
fuse
location
available,
Put a spring contact (5) on each of the two cable
ends and connect them to the fuse holder (4).
Insert the supplied 20A fuse into the fuse
holder (4).
(2,5
mm²)
with
Look for a available ignition (terminal 15), not
used for a relay control module (not included in
the scope of delivery).
Interrupt the battery connection (+) and insert the
supplied 20 A fuse.
direct
cable
ignition
current
13
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
