Rommelsbacher EKS 2000 Bedienungsanleitung Seite 39

Step 13:
Choose the function
"espresso/hot water".
Step 17:
Switch the appliance off.
Step 21:
Empty the water tank and clean it
thoroughly.
Step 25:
Place a vessel below the outlet of
the portafilter.
Step 14:
Switch the appliance on again.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 18:
Remove the vessel.
Step 22:
Fill the water tank with fresh tap
water.
Observe the "MAX" marking!
Step 26:
Choose the function
"espresso/hot water".
Step 15:
Continue the descaling process by
turning the rotary knob to the right.
Dispense decalcifier for15 seconds.
Step 19:
Remove the portafilter.
Attention, the portafilter drips
slightly.
Step 23:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 27:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 16:
Stop the supply.
Turn the rotary knob to the left.
Step 20:
Remove the water tank.
Step 24:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
CONTINUED ON
NEXT PAGE
39