Searching A Station Manually: Manual Search - JVC kd-lh3101 Bedienungsanleitung

Searching a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Each time you press the button,
the band changes as follows:
FM1 FM2
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Press and hold ¢
until "Manual Search" starts flashing
on the display.
3
Tune in to a station you want while
"Manual Search" is flashing.
To tune in to stations of lower frequencies
FM3 AM
or 4
To tune in to stations
of higher frequencies
• If you release your finger from the button,
the manual mode automatically turns off
after about 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for
FM and 9 kHz for AM—MW/LW) until you
release the button.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce this
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
"To change the FM tuner selectivity—IF Filter"
on page 51.
11