Bender ISOMETER isoCHA425 Schnellstart Seite 10

ISOMETER® isoCHA425
Anschluss
Anschlussart ..................................................................Federklemme
Nennstrom ...............................................................................≤ 10 A
Leitergrößen .....................................................................AWG 24-14
Abisolierlänge ..........................................................................10 mm
Starr ............................................................................ 0,2...2,5 mm²
Flexibel ohne Aderendhülse .................................
Flexibel mit Aderendhülse mit/ohne Kunststoffhülse ........................
.................................................................................. 0,25...2,5 mm²
Mehrleiter flexibel mit TWIN Aderendhülse mit Kunststoffhülse .......
.................................................................................... 0,5...1,5 mm²
Öffnungskraft ...............................................................................50 N
Testöffnung, Durchmesser ......................................................2,1 mm
Sonstiges
Betriebsart ..................................................................... Dauerbetrieb
Einbaulage ..........Kühlschlitze müssen senkrecht durchlüftet werden
Schutzart Einbauten (DIN EN 60529) ...........................................IP30
Schutzart Klemmen (DIN EN 60529) ............................................IP20
Normen, Zulassungen und Zertifizierungen
Das ISOMETER® wurde unter Beachtung folgender
Normen entwickelt:
• DIN EN 61557-8 (VDE 0413-8): 2015-12/Ber1:
2016-12
• IEC 61557-8 -8: 2014/COR1: 2016
10 isoCHA425_D00352_01_Q_DEEN/ 05.2021
Connection
Connection type ................................................... push-wire terminal
Nominal current .......................................................................≤ 10 A
Conductor sizes .................................................................AWG 24-14
Stripping length .......................................................................10 mm
Rigid ........................................................................... 0.2...2.5 mm²
0,75...2,5 mm² Flexible without ferrules
Flexible with ferrules with/without plastic sleeve .............................
.................................................................................. 0.25...2.5 mm²
Multi-conductor flexible with TWIN ferrules with plastic sleeve ........
.................................................................................... 0.5...1.5 mm²
Opening force ..............................................................................50 N
Test opening, diameter ...........................................................2.1 mm
Other
Operating mode .................................................. continous operation
Mounting .......................... cooling slots must be ventilated vertically
Degree of protection built-in components (DIN EN 60529) ..........IP30
Degree of protection terminals (DIN EN 60529) ...........................IP20
Standards, approvals and certifications
The ISOMETER® has been developed in compliance
with the following standards:
• DIN EN 61557-8 (VDE 0413-8): 2015-12/Ber1:
• IEC 61557-8 -8: 2014/COR1: 2016
.........................................
2016-12
0.75...2.5 mm²