Teaching The User; Adjustment Options / Features - Thomashilfen EASyS Advantage Gebrauchsanweisung

Instructions for Use – EASyS Advantage seat unit

Teaching the User

The user is taught how to use this device by trained staff who will reference these Instructions for Use.

Adjustment Options / Features

The settings / adjustments must always be made by trained / instructed professionals (such as medical product consult-
ants of specialist medical dealers).
Seat unit
Inserting the seat unit
Activate the release lever on the backrest and insert the seat unit into the chassis from above (Fig. 3). Make sure that the
buttons on the sides of the seat unit between the folding joint and the connecting strap of the rear frame and the sliding
support are properly threaded through (Fig. 4). Now guide the buttons on the sides of the seat unit into the receiving
slots on the sides of the chassis (Fig. 5) and let the seat unit slide into position (Fig. 6). When you release the trigger, the
seat unit engages into the closest position of the hole matrix.
Caution: Always ensure that the locking pins on both sides of the seat unit engage firmly into a hole in the hole matrix.
Removing the seat unit
To remove the seat unit, actuate the release lever and pull the seat unit upwards out of the frame (Fig. 3). Make sure that
the buttons on the sides of the seat unit between the folding joint and the connecting strap of the rear frame and the
sliding support are properly threaded through (Fig. 4).
Attaching the footrest
The footrest must be fastened to the knee joints. To do this, align the ratchet joints and fasten them to the screws (from
the inside), the saddles (from the outside) and the eccentric levers (from the outside; Fig. 7).
Upholstery
Seat cushion
The seat cushion consists of two elements: the main gray cushion as well as a black additional pad for more comfort.
The additional pad is attached with hook and loop to the underside of the main cushion (Fig. 8). In this regard, pay
attention that the notch in the additional pad is facing forward (Fig. 9). Fasten the seat cover by firmly attaching it to
the rear end of the seat plate using the hook and loop flap (Fig. 10). The lower two hook and loop straps are wrapped
around the tubes of the footrest.
If necessary, the additional pad can be removed.
Backrest upholstery
The backrest upholstery is attached at the top of the back plate, as is the hook and loop strip on the back plate (Fig. 11).
The lower part of the backrest upholstery is inserted to the rear between the seat and the back (Fig. 12). The lower end
is provided with hook and loop and is attached to the rear end of the seat plate to close the gap between the seat and
the back (Fig. 13).
Side cushion
Place each of the shorter cushions of the two side cushion pairs over the side tubes so that the hook and loop is facing
inward (Fig. 14). The hook and loop fastener is located on the outside of the back plate curve. Attach the cushion in
such a manner that the upper edge of the cushion on the back ends just below the thumbscrew (Fig. 15). Then attach
the rear of the cushion with hook and loop (Fig. 16). The zippers of the shorter side cushion can be positioned inwards
if necessary.
Hook and loop each of the longer cushions to the inside of the back plate curve. The longer cushions are attached at a
height where they are flush with the top end of the outer side cushions (Fig. 17).
24
2021-04