Seat Width; Back Height - Thomashilfen EASyS Advantage Gebrauchsanweisung

Instructions for Use – EASyS Advantage seat unit
Lateral seat upholstery
The lateral seat upholstery can be opened with a zipper. It is pulled over the seat side guides in such a manner that the
strip on the outside runs from the rear / top to the front / bottom (Fig. 18).
Holders for sun and rain cover
The EASyS Advantage comes with holders for the sun and rain cover (without leg blanket) as standard (Fig. 19). Their
height can be adjusted as required. To do so, loosen the screws of the holders for the sun and rain cover and move it on
the tubes into the desired position. Then tighten the screws firmly again.
Calf strap
The calf strap is affixed between the two lateral posts of the footrest and supports the user's lower legs. (Fig. 47)

Seat width

To adjust the seat width, loosen the four soft-touch nuts under the seat of the EASyS Advantage and move the side ele-
ments accordingly (Fig. 20). Then retighten the nuts. If the seat depth is set to the minimum depth, the maximum adjust-
able seat width depends on the gap before the lateral seat upholstery of the back.
Seat depth
Loosen the two front soft-touch nuts under the seat of the EASyS Advantage and pull the seat plate forwards (Fig. 20).
Then retighten the nuts.
Tip: To easily adjust the seat depth, use one hand to grip the front edge of the seat and use the other to hold the lower
end of the back (in the center) steady. The depth of the seat side guide can also be adjusted. To do so, open the cush-
ions of the seat side guides with the zippers and remove them. Loosen the two screws, set the desired depth and retight-
en the screws (Fig. 21).

Back height

Loosen the two thumbscrews on the side tubes (Fig. 22). Now the height of the backrest can be infinitely adjusted up
to the engagement point (spring pins engage with a click). To reduce the back height, press the spring pins below the
thumbscrews and slide the back plate downwards to the desired height (Fig. 23).
To achieve the maximum back height, also loosen both thumbscrews on the upper cross bar and pull the back plate
upwards (Fig. 24). Then retighten all the thumbscrews.
Tip: The extended tubular bar provides additional safety for children who are predominantly transported in the horizon-
tal position.
Angle of recline
Loosen the clamping lever on the backrest (Fig. 25) and remove the safety pin below the lever (Fig. 26). Now the back-
rest can be brought into the desired position. The seat unit automatically slides forwards on the rails, moving the center
of gravity (Fig. 27). It must be ensured that the pin clicks back into place. Finally, retighten the clamping lever after the
position has been set.
Note: The seat units have a different number of holes for the safety pin on the backrest
(EASyS Advantage size 1: 2 holes; EASyS Advantage size 2: 4 holes).
When transporting the rehab stroller in a vehicle, the safety pin must always engage into the lowermost hole (90° seat
angle). The other holes can be used to set other commonly used seat angles.
25
2021-04