Nibe HPAC S40 Installateurhandbuch Seite 32

Heating, auto
Alternative: on/off
Speed in wait mode
Setting range: 1 - 100 %
Hot water, auto
Alternative: on/off
Active cooling, auto
Alternative: on/off
Active cooling, manual
Setting range: 1 - 100 %
Passive cooling, auto
Alternative: On/Off
Passive cooling, manual
Setting range: 1 - 100 %
Speed during active cooling
Setting range: 1 - 100 %
Heating, auto: Here, you set whether the heating medi-
um pump is to be regulated automatically or manually.
Minimum permitted speed: Here, you can restrict the
pump speed to ensure that the heating medium pump
is not allowed to operate at a lower speed in auto mode
than the set value.
Heating, manual: If you have opted to control the heating
medium pump manually, you set the desired pump
speed here.
Speed in wait mode: Here, you set the speed the heat-
ing medium pump will have in standby mode. Standby
mode occurs when heating operation is permitted but
there is no need for either compressor operation or
electric additional heat.
Speed in wait mode: Here, you set the speed the heat-
ing medium pump will have in standby mode. Standby
mode occurs when heating or cooling operation is per-
mitted but there is no need for either compressor oper-
ation or electric additional heat.
Active cooling, auto: Here, you set whether the heating
medium pump is to be regulated automatically or
manually.
Active cooling, manual: If you have opted to control the
heating medium pump manually, you set the desired
pump speed here.
Passive cooling, auto: Here, you set whether the heating
medium pump is to be regulated automatically or
manually.
Passive cooling, manual: If you have opted to control
the heating medium pump manually, you set the desired
pump speed here.
32
Maximum permitted speed: Here, you can restrict the
pump speed to ensure that the heating medium pump
is not allowed to operate at a higher speed than the set
value.
MENU 7.1.2.7 - PUMP SPEED BRINE
Make settings for the brine pump's speed here.
Speed in passive cooling
Setting range: 1 - 100 %
Speed during active cooling
Setting range: 1 - 100 %
Delta-T cooling
Setting range: 2 - 10 °C
Speed in wait mode, cooling
Setting range: 1 - 100 %
Speed in passive cooling: Here you set the speed at
which the brine pump will operate during passive cool-
ing.
Speed during active cooling: Here, you set the speed
the brine pump will have during active cooling.
Delta-T cooling: Here, you set whether the brine pump
is to be regulated with fixed delta during cooling opera-
tion.
Speed in wait mode, cooling: Here, you set the speed
the brine pump will have in standby mode. Standby
mode occurs when active cooling is permitted but there
is no need for compressor operation.
MENU 7.1.7 - COOLING
This menu contains sub-menus where you can make
advanced settings for cooling operation.
HPAC S40 | GB