Inspection Of The Installation; Transport And Storage - Nibe HPAC S40 Installateurhandbuch

ELECTRICAL CONNECTION
AA5-F1
AA5-X10
AA5-X9
AA5-X2 AA5
W101
SF1 Switch
AA5 Accessory card
AA5-X2 Terminal block, sensors and external blocking
AA5-X4 Terminal block, communication
AA5-X9 Terminal block, circulation pump and reversing
valves
AA5-X10 Terminal block, reversing valves
AA5-S2 DIP switch
AA5-F1 Fine wire fuse (T4A, 250V)
W101 Cable with connection plug, supply
W102 Cable, communication with heat pump or previ-
ous accessory card

TRANSPORT AND STORAGE

HPAC S40 must be transported and stored horizontally
and dry.
NOTE
Do not use the pipes as a handle.
HPAC S40 | GB
SF1
AA5-X4
AA5-S2
W102
MOUNTING
HPAC S40 is installed on the wall.
First screw the enclosed suspension bracket into place
on the wall. Then hang HPAC S40 on the bracket.
HPAC S40 can now be slid sideways to some extent,
which facilitates the fitting of the pipes.
TIP
Install the accompanying securing plate any-
where at the bottom rear of the cooling module
for further fastening.

INSPECTION OF THE INSTALLATION

In accordance with current norms, the heating/cooling
installation must undergo an installation check before
being used. The inspection must be carried out by a
suitably qualified person and should be documented.
The above applies to closed heating/cooling installations.
Replacement of the heat pump or the HPAC module is
not permitted without renewed inspection.
23