Herunterladen Inhalt Inhalt Diese Seite drucken

Adding Fuel And Engine Oil - AL-KO Snow Line 560 II Betriebsanleitung

Vorschau ausblenden Andere Handbücher für Snow Line 560 II:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
GB
4. Insert the guide plates into the discharge chute
from beneath and tighten with the self-locking
12-1).
nuts (
5. Repeat the procedure for the other two guides
x The snow discharge chute is attached.
Attaching snow discharge chute hand crank
1. Remove the handle from the crank by removing
the mounting screw (
2. Insert the hand crank from the handle side from
below into the guide on the guide handle (
3. Remove the safety split pin and washer under-
neath using pliers (
4. Insert the hand crank into the lower guide on
the snow discharge chute. The snow discharge
chute must be positioned such that the spiral of
the hand crank fits into the grooves of the chute
(
16-1).
If it is difficult or impossible to move the hand
crank to the lower guide, it may be necessary
to adjust the upper guide. To do this, loosen the
screws slightly and re-tighten after adjusting (
14-1).
5. Attach the washer and insert the safety split pin
17-1).
using pliers (
6. Bend the ends of the safety split pin (
7. Screw the handle onto the crank (
x The hand crank is attached.
Checking the tyre pressure
The maximum allowed tyre pressure is indicated on
20-1). Note: 1 bar = approximately 14.5
the tyres (
psi
Pump up both tyres to the same pressure level using
the tyre pump.
Attaching the headlight (620E II)
1. Insert the pre-assembled headlight from the front
through the guide handle using the mounting
21-1). Do not twist or damage the
screw (
cable!
2. Fasten the headlight using the washer and self-
locking nut.
3. Fasten the cable to the guide handle using cable
clips.
x The headlight is attached.
26
13).
14).
15).
18).
19).
Autogoods "130"

Adding fuel and engine oil

Always follow the instructions in the engine
operating manual provided.
Fuel the snow blower and add oil before use.
Danger - fire hazard!
Petrol and oil are highly flammable!
Fuel and lubricant
Petrol
Type
Regular lead-free
petrol (86 octane
or higher)
Engine is E10-
compliant.
Filling
3 l
quantity
Translation of original user instructions
AL-KO snow blower
Engine oil
SAE 5W-30
recommended
0,6 l

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Snow line 620 iiSnow line 620e ii

Inhaltsverzeichnis