Adding Fuel And Engine Oil - AL-KO Snow Line 560 II Betriebsanleitung

GB
4. Insert the guide plates into the discharge chute
from beneath and tighten with the self-locking
nuts ( 12-1).
5. Repeat the procedure for the other two guides
» The snow discharge chute is attached.
1. Remove the handle from the crank by removing
the mounting screw ( 13).
2. Insert the hand crank from the handle side from
below into the guide on the guide handle (
3. Remove the safety split pin and washer under-
neath using pliers ( 15).
4. Insert the hand crank into the lower guide on
the snow discharge chute. The snow discharge
chute must be positioned such that the spiral of
( 16-1).
crank to the lower guide, it may be necessary
to adjust the upper guide. To do this, loosen the
screws slightly and re-tighten after adjusting (
14-1).
5. Attach the washer and insert the safety split pin
17-1).
using pliers (
6. Bend the ends of the safety split pin (
7. Screw the handle onto the crank (
» The hand crank is attached.
Checking the tyre pressure
The maximum allowed tyre pressure is indicated on
the tyres ( 20-1). Note: 1 bar = approximately 14.5
psi
Pump up both tyres to the same pressure level using
the tyre pump.
1. Insert the pre-assembled headlight from the front
through the guide handle using the mounting
screw ( 21-1). Do not twist or damage the
cable!
2. Fasten the headlight using the washer and self-
locking nut.
3. Fasten the cable to the guide handle using cable
clips.
» The headlight is attached.
26

Adding fuel and engine oil

Always follow the instructions in the engine
operating manual provided.
Fuel the snow blower and add oil before use.
Fuel and lubricant
14).
Type
Filling
quantity
18).
19).
AL-KO snow blower
Petrol Engine oil
Regular lead-free SAE 5W-30
petrol (86 octane recommended
or higher)
Engine is E10-
compliant.
3 l 0,6 l
Translation of original user instructions