Installation On Unify Level Base - Clearaudio swing base Bedienungsanleitung

User manual / Bedienungsanleitung

3. Installation on Unify level base

Please install the appropriate tonearm base on your turntable first. For a turntable of the
Clearaudio Innovation series you will need the Unify base (Art. No. AC030-4, available from your
Clearaudio dealer). Ensure that you set the correct distance of 222mm between platter spindle
and tonearm pivot.
Pic. 9: Unify level base
Pic. 11: Mounting of the level base
Now you can thread the tonearm cables of the TT5 tonearm through the upper part of the
base
(not yet assembled) and through the opening of the assembled lower part and tonearm hole
of the chassis (see pic 12).
Insert the foot of the TT5 through both components of the
allowing the upper ring to rest loosely (see pic. 13).
Pic. 12: Threading the cables through the
swing base
Made in Germany
Pic. 10: Mounting of the Unify level base
swing base
Take the
Remove the adhesive tape used to secure both parts
during transport.
The upper part of the
for the time being.
Place the lower part of the
tonearm base, such that the holes of both bases are
aligned.
The arrow on the lower part should point towards
the platter (see picture 11). Use the M4 x 16 screws
and the hex wrench #3 (provided) to tighten the
lower part of the tonearm base.
swing base
Pic. 13: Inserting the cables in the tonearm
base
out of the box.
swing base
can be put aside
swing base
into the tonearm hole,
Page / Seite 7
on the
swing