Clearaudio swing base Bedienungsanleitung Seite 5

User manual / Bedienungsanleitung
swing base
Take the
transport.
Pic. 4: Mounting of the swing base
Now you can thread the tonearm cables of the TT5 tonearm through the upper part of the
base
(not yet assembled) and through the opening of the assembled lower part and tonearm hole
of the chassis (see pic 5).
Insert the foot of the TT5 through both components of the
allowing the upper ring to rest loosely (see pic. 6).
Pic. 5: Putting the cables through the
swing base
The installation of the
TT5 tangential tonearm, following the TT5 user manual.
Once the tonearm has been fully adjusted, you will need to fix the upper part of the
Here, you can opt for the direction in which the tonearm will swung out.
Made in Germany
out of the box. Remove the adhesive tape used to secure both parts during
The upper part of the
being.
Place the lower part of the
such that the holes of both bases are aligned.
The arrow on the lower part should point towards the platter
(see picture 4). Use the M4 x 16 screws and the hex wrench
#3 (provided) to tighten the lower part of the tonearm base.
swing base
is now completed and you are ready to mount and adjust the
swing base
swing base
swing base
Pic. 6: Inserting the cables in the tonearm base
can be put aside for the time
on the tonearm base,
into the tonearm hole,
swing base
Page / Seite 5
swing
.