Clearaudio swing base Bedienungsanleitung Seite 8

User manual / Bedienungsanleitung
swing base
The installation of the is now completed and you are ready to mount and adjust the TT5
tangential tonearm, following the TT5 user manual.
swing base
Once the tonearm has been fully adjusted, you will need to fix the upper part of the .
Here, you can opt for the direction in which the tonearm will swung out.
swing base
If the tonearm is to swing out counterclockwise (to the right), then the upper part of the
must be tightened in the position as shown in picture 14b.
Pic 14b: Mounting direction of the upper part
(to the right)
Pic 14a: Direction of the tonearm
swing base
If the tonearm is to swing out clockwise (to the rear), then the upper part of the must
be screwed in the position as shown in Picture 15b.
Pic 15b: Mounting direction of the upper part
(to the rear)
Pic. 15a: Direction of the tonearm
swing base
Now you can tighten the screws of the upper part of the with the hex wrench #2.
swing base
Finally, re-check all settings again. The TT5 with is now ready to use.
Page / Seite 8 © clearaudio electronic GmbH, 2021-04