Clearaudio swing base Bedienungsanleitung Seite 6

User manual / Bedienungsanleitung
If the tonearm is to swing out counterclockwise (to the right), then the upper part of the
must be tightened in the position as shown in picture 7b.
Pic. 7a: Direction of the tonearm
If the tonearm is to swing out clockwise (to the rear), then the upper part of the
be screwed in the position as shown in picture 8b.
Pic. 8a: Direction of the tonearm
Now you can tighten the screws of the upper part of the
Finally, re-check all settings again. The TT5 with
Page / Seite 6
Abb. 7b: Mounting direction of the upper part
(to the right)
Pic. 8b: Mounting direction of the upper part
(to the rear)
swing base
with the hex wrench #2.
swing base
is now ready to use.
© clearaudio electronic GmbH, 2021-04
swing base
swing base
must