Installation - Marley PREMIUM P14 Montageanleitung; Betriebsanleitung

ENGLISH
GB GB
Dear Customer,
To guarantee the safety and correct working of the appliance, please read the following instructions
CAREFULLY before beginning the installation.
IMPORTANT:
Make sure that the power supply has been disconnected before per-
forming the installation or electrical connection of the appliance.
Installation, electrical connections and settings must be carried out by a
qualified person in line with local regulations.
If these installation instructions are not followed the product may be
damaged.
For optimal performance, the appliance must be installed correctly (in-
stallation of the unit, ducts and air replacement inlets).
This extractor fan is designed for the ventilation of households or similar
premises. Do not use for any purpose other than that for which it was
designed.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and under-
stand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
The fan is to be installed so that the blades are more than 2,3 m above
the floor.
This extractor fan does not produce radio/television interference (Direc-
tive 2004/108/EC).
Prior to piping installation, consult the municipal by-laws on
air outlets and request permission from the person responsible for the
building.
Precaution must be taken to avoid the backflow of gases into the room
from the open gas pipe or from other open-flame devices.
The room must have adequate ventilation if this appliance is used simul-
taneously with other appliances that run on gas or other fuels.
Do not install the exhaust conduit (D) of the extractor fan to a chimney
flume, ventilation pipes, hot air ducts or ducts used to evacuate fumes
from appliances that run on gas or other fuels.
10
DO NOT install this product in areas with the follow charac-
teristics:
• Excess of oil or grease.
• Areas with corrosive or flammable liquid gas or vapour.
• Areas with temperatures higher than 40 °C or lower than -5 °C.
• Areas exposed to the environment (rain, sun, snow, etc.)
• Areas with possible obstacles that obstruct the access to the fan.
The product and its parts must not be submerged in water or other liq-
uids.
The IP rating is only valid if the installation of the appliance complies
with what is indicated in this manual.
The manufacturer declines all responsibility for personal injury or dam-
age to animals or objects caused by inappropriate use of the appli-
ance according to the warnings for installation, use and maintenance
described in this instruction manual.
After finishing the installation these instructions should be given to the
owner/user of the appliance.
The appliance must be able to be disconnected from the mains electric-
ity supply after installation.
It can be disconnected by making the plug accessible or by incorporat-
ing a switch in the fixed wiring that meets electrical installation stand-
ards.

INSTALLATION:

Before starting the installation, check that the propeller is not deformed
or damaged, that it can turn freely, and that no foreign body is lodged
inside the outer casing."
The appliance shall be installed according to the attached graphic doc-
umentation. It may be installed on the wall or ceiling, with direct exhaust
to an individual exhaust duct (see fig. 1)
To install, make a circular hole with a diameter of 100 mm in the wall or
ceiling where the appliance will be installed, together with the holes for
fixing it (see fig. 4 and 5).