Work Sharp WSKTS2-I Bedienungsanleitung Seite 7

h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles and
grasping surfaces do not allow for safe handling and control of the tool in unexpected situations. Hold
the power tool by insulated gripping surfaces, because the sanding surface may contact its own cord.
Cutting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an
electric shock.
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only identical replacement
parts . This will ensure that the safety of the power tool is maintained.
WORK SHARP, LLC
Mail .......................210 E. Hersey St. Ashland, OR 97520 USA
Phone ....................1 (800) 597-6170
Fax ........................1 (541) 552-1377
E-mail ..................info@worksharptools.com
Web .......................www.worksharptools.com
b) Do not dispose of electrical products with household waste . Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
c) To replace a damaged power supply cord (Type Y), your power tool must be returned to the
Service Center.
BELT SANDER SAFETY RULES
• WARNING: Hold the power tool by insulated gripping surfaces, because the sanding surface may
contact its own cord . Cutting a "live" wire may make exposed metal parts of the power tool "live" and could give
the operator an electric shock.
• WARNING: ALWAYS use proper safety glasses . Everyday eyeglasses are NOT safety glasses. Also use face
or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT .
• WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and
permanent respiratory or other injury. Always use NIOSH/ OSHA approved respiratory protection appropriate for
the dust exposure. Direct particles away from face and body.
• CAUTION: Wear appropriate hearing protection during use. Under some conditions and duration of
use, noise from this product may contribute to hearing loss.
• Always hold tool firmly.
• Use clamps or another practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and wash exposed areas with soap and water.
Allowing dust to get into your mouth, eyes, or lie on the skin may promote absorption of harmful
chemicals.
• Do NOT energize tool unless the sharpening cassette is firmly engaged in either the sharpening
or grinding position .
S A F E T Y I N F O R M A T I O N | 7