Motorola MTP6000 CAR KIT Installationsanleitung Seite 9

M4 x 10 mm Screw (x4)
Wipe clean flat surface
before using adhesive
pad
Hinge Screw
#8 x .625" Self Tapping
Figure 1: Vehicular Cradle, RSM Bracket, and Mounting
When installing the Vehicular Cradle, use the following
procedure or modify to suit the particular vehicle. See Figure
1 above:
1. Open the hinge screw and separate the two halves of the
mounting bracket.
2. Use the lower half of the bracket as a template. Position it
so that the pivot end of the bracket is toward the bottom
of the cradle.
3. Using an awl or similar device, make four holes in the
carpet at marked locations. This must be done prior to
drilling to avoid damaging the carpet.
4. Mark and drill holes. Securely mount the bracket half
using the four #8 x .625" self tapping screws (supplied
with the mounting bracket).
5. Secure the cradle to the other half of the bracket using
the four M4 x 10 mm screws, you may choose to
sandwich the RSM bracket in between or install it
separate as shown in Figure 1.
6. Connect the two parts of the mounting bracket and
secure the hinge screw.
7. Align the RSM bracket and the cradle to the four holes of
the mounting bracket, then secure with four M4 x 10 mm
screws.
Screw (x4)
Bracket
7