Motorola MTP6000 CAR KIT Installationsanleitung Seite 20

1. If the car is not equipped with an internal power supply
connection, route red and black leads of the main power
cable through the bulkhead and into the engine
compartment. Use an existing opening or, if necessary,
drill a 2 cm (26/32 inch) diameter hole through the
bulkhead. Insert a grommet into the hole to prevent
damage to the power cable. The red and black leads
should be inserted one by one into the hole.
2. Cut the black lead to the desired length and connect it to
the chassis of the vehicle. Verify that the fuse is at a
distance of 20 cm to 30 cm away from the connection
point.
3. On the engine side of the bulkhead, connect the red (A+)
lead to the vehicle battery as follows:
a. Cut the long red lead to the desired length, strip the
edge and crimp a terminal lug (not included) to the
lead. Verify that the fuse is at a distance of 20 cm to
30 cm away from the connection point.
b. Connect the red lead to the positive (+) terminal on the
vehicle battery. Cable tie the wire every 10 cm
(4 inches) along its length.
4. Verify that the cables in the engine compartment do not
obstruct any of the vehicle controls or come in contact
with hot or moveable parts of the engine.
5. For ignition installation, perform the following steps:
a. Cut the long blue lead to the desired length, strip the
edge and crimp a terminal lug (not included) to the
lead. Verify that the fuse is at a distance of 20 cm to 30
cm away from the connection point. It is not a good
practice to connect the leads to the battery pillars; use
the closest battery connection provided. The Car Kit
could be damaged if there is a malfunction in the
electrical system of the vehicle.
b. Connect the blue lead to the ignition switch. Verify that
the voltage is high when ignition is on, during
cranking, and while vehicle is moving. When ignition is
off, the voltage is low.
18