Basic Connections; Connecting The Antenna; Routing Cables - Pioneer PDP-LX608D Bedienungsanleitung

Preparation
Caution
• A table or rack with adequate strength should always be used to
support the plasma television. Failure to do so could result in
personal injury and physical damage.
• When installing the plasma television, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes, or of
accidents.
• If you do not take these precautions, the plasma television could
fall down and cause injury.
• The screws, hooks, cords and other fittings that you use to
secure the plasma television to prevent it from overturning will
vary according to the composition and thickness of the surface
to which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Caution
• When the "Aerial Power" setting is on, directly connect the
aerial to the ANT input terminal at the rear of the plasma
television. Connecting any device between the aerial and
plasma television may cause damage to the device.
Rear view
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
• If "Aerial Power" setting is enabled, use an indoor antenna with
signal amplifier, 5 V 30 mA.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma television.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.

Routing cables

When the speaker is installed under the plasma television panel
(PDP-LX508D/PDP-LX5080D):
Rear view
Bead band
Note
• Use the supplied bead bands as necessary.
• When tidying up your speaker cables, make sure to bundle them
so that they are not subjected to any pressure.
Speaker cable
05
17
En