Gastrodomus MK225 Handbuch Zur Installation, Bedienung Und Wartung Seite 23

PUT IN FUNCTION
The machine operator can put in function the machine following in order the under reported indications:
1. positive controls result for the preparation preliminary operations,
2. positive controls result for the electric feeding,
3. plug connection in opportune current socket,
4. positive controls result for the assembly,
5. positive controls result / checks before the starting,
6. positive controls result finalized to check the respect of all safety conditions,
7. introduce manually the feed product inside the pot,
8. with the use of both the hands take the machine in the foreseen zones:
a. place it with the tool inside the pot,
b. start, maintain and handle it up to the end of the feed product work,
9. when the food product has reached the desired solidity, stop the machine and placed on a support
adequate bench,
10. discharge manually the pot feed product, taking it with both the hands and pouring out the feed
product where necessary.
It is forbidden to introduce the machine in the pot, more than the immersion nick and however over
the tool blocking nut
It is recommended to make not work the machine on vacuum.
We recommend to control periodically the tire gasket integrity placed under
the blade (see drawing) and change it if it is damaged or worn.
The gasket integrity prevents the working product seepage inside the tool
avoiding damages to the mixer.
SWITCHING OFF
In succession, the switching off must follow what here under indicated:
1. before the switching off wait the working conclusion, or wait that the feed product has reached the desired solidity,
2. stop the machine releasing the foreseen control devices,
3. place the machine on a support adequate bench,
4. disconnect the plug from the machine from the feeding socket,
5. perform the cleaning interventions.
CHAP. 5. MAINTENANCE, BREAKS RESEARCH AND CLEANING
MAINTENANCE PRESCRIPTIONS
INSULATION FROM THE EXTERNAL FEEDING SOURCES
Before to perform any operation of maintenance, cleaning and parts change, the external feeding sources must be
sectioned and insulated.
ORIGINAL INSTRUCTIONS TRANSLATION
Position on "zero" the protection device placed upstream of
the electric equipment feeding line.
Disconnect the general sectioning device and provide to
protect the plug with proper systems.
23