DeWalt DC222 Bedienungsanleitung Seite 32

E N G L I S H
Hammer drilling (fig. A)
• Set the mode selector switch (3) to the „hammer
drilling" position.
• Insert the appropriate drill bit. For best results
use high quality carbide-tipped bits.
• Adjust the side handle (9) as required.
• If necessary, set the drilling depth.
• Mark the spot where the hole is to be drilled.
• Place the drill bit on the spot and switch on the
tool.
Rotary drilling (fig. A)
• Set the mode selector switch (3) to the "rotary
drilling" position.
• Depending on your tool, follow either of the
following instructions:
– Fit a chuck adaptor/chuck assembly (DC222/
DC223). Special SDS-plus adaptors with
threaded sections are available for use with
standard 10 or 13 mm chucks to enable straight
shank bits to be used.
– Replace the tool holder with the chuck (DC224).
• Proceed as described for hammer drilling.
Never use standard chucks in the
hammer drilling mode.
Screwdriving (fig. A)
• Set the mode selector switch (3) to the "rotary
drilling" position.
• Select the direction of rotation.
• Depending on your tool, follow either of the
following instructions:
– Insert the special SDS-plus® screwdriving
adaptor for use with hexagonal screwdriver bits
(DC222/DC223).
– Replace the tool holder with the chuck (DC224).
• Insert the appropriate screwdriver bit. When
driving slotted head screws always use bits with
a finder sleeve.
• Gently press the variable speed switch (1) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
• When the screw is flush with the workpiece,
release the variable speed switch to prevent the
screw head from penetrating into the workpiece.
32
DC223/DC224 - Chipping (fig. A)
• Set the mode selector switch (3) to the
„hammering only" position.
• Insert the appropriate chisel and check if it is
properly locked.
• Adjust the side handle (9) as required.
• Switch on the tool and start working.
It may be necessary to briefly run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
Optional accessories
Various types of SDS-plus® drill bits and chisels are
available as an option.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• This machine is not user-serviceable. Take the
tool to an authorised D
approximately $40 hours of use. If problems
occur before this time contact an authorised
D WALT repair agent.
E
Lubrication
Your power tool requires no additional lubrication.
Accessories and attachments used must be
regularly lubricated around the SDS-plus® fitment.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
WALT repair agent after
E