7�2�3� Upper Body - InterCo Skippy Gebrauchsanweisung

7.2.3. Upper body
Lateral side supports
The lateral side supports can be adjusted via the two
screws on each side of the back (Fig� 19)� If the adjust-
ment in the standard position is not sufficient, the back
rest offers further mounting options� To do this, the lat-
eral side support must be removed and reassembled�
Fold the cover of the back rest to the side

Loosen the screws

Adjust the lateral side support

Tighten the screws

Replace the cover

Lateral side supports off-set
The lateral side supports off-set can be mounted us-
ing the two screws on the respective side of the back
(Fig� 19)� If the adjustment in the standard position is
not sufficient, the back rest offers further mounting
options� To do this, the lateral side support off-set must
be removed and reassembled�
Fold the cover of the back rest to the side

Loosen the screws

Adjust the lateral side support

Tighten the screws

Replace the cover

Lateral side supports, insertable
The lateral side supports can be removed by pressing
the red lever on the outside of the lateral side supports
(Fig� 20)� To reinsert, simply push the removed lateral
side support back into the mating part�
Assembly
It is best to remove the back cushion for assembly� Now
the standard lateral side supports must be removed�
To do this, the screws are completely removed� The
insertable lateral side supports are mounted at the
correct height, approx� 2 finger widths under the height
of the armpits� To do this, use the screws that were
just removed� Afterwards velcro the back rest cushion
back in place�
Lateral side supports, foldable
The foldable lateral side supports can be folded down
by pressing the red lever located on the outside of the
lateral side supports (Fig� 21)� When folding them back,
the lateral side supports snap into place by themselves�
Assembly
It is best to remove the back cushion for assembly� Now
the standard lateral side supports must be removed�
To do this, the screws are completely removed� The
insertable lateral side supports are mounted at the
correct height, approx� 2 finger widths under the height
of the armpits� To do this, use the screws that were
just removed� Afterwards velcro the back rest cushion
back in place�
Fig 19
Fig 20
Fig 21
SETTINGS / OPERATION
43