7�1�2� Undercarriage - Interco Skippy Gebrauchsanweisung

Adjusting the back height
The back height of the SKIPPY
to 7cm� To do this, loosen the two screws on the back
(Fig� 5)�
Fold the cover of the back rest to the side

Loosen the screws

Adjust the back height

Tighten the screws

Replace the cover

Back angle adjustment
The back angle of the SKIPPY
red clamping lever� (Fig� 6)
Loosen both clamping levers on the back with two

turns
Adjust the back angle

Tighten the red clamping levers

Dynamic back rest
The dynamic back rest of the SKIPPY
tightening the blue clamping lever on the back� (Fig� 6)
To release the dynamic back rest, release the blue
clamping lever with a maximum of 2 turns�
7.1.2. Undercarriage
Height adjustment mechanism
The height adjustment can be activated via the red but-
ton in the frame (Fig� 7)� When lowering, pressure must
be applied from above� Raising works without manual
intervention�
Tilt-in-space mechanism
The seat tilt is activated via the red lever behind the
seat shell� (Fig� 8) For tilting, as well as for straighten-
ing, manual assistance is required�
Steering wheels with locks
The SKIPPY is fitted with steering rollers with locks
®
with a diameter of 75 mm as standard� Steering roll-
ers with locks can also be ordered with a diameter of
100 mm� If these are retrofitted, they can simply be
loosened with a spanner and the new rollers screwed
in (Fig� 9)�
Important!
The rollers must not be retrofitted while
the user is sitting in the product�
Important!
Loctite or screw retention must be used
for securing!
40
SETTINGS / OPERATION
can be adjusted by up
®
can be adjusted via the
®
can be fixated by
®
Fig 5
Fig 6
Fig 7
Fig 8
Fig 9