AEG BHG 750W Bedienung Und Installation Seite 13

5.
Clean the surfaces when cold with a soft cloth and ordi-
nary cleaning products.
Note
6. Troubleshooting
6.1
The heated air This can be caused
smells unpleasant. by dust during com-
missioning.
The appliance The MCB/fuse has
does not heat up. responded/blown.
The appliance The appliance is sub-
heats continuously. ject to a continuous
draught.
The temperature set-
ting was changed.
There is a fault with
the power supply.
The 24 h automatic There was a power
function is not per- failure.
formed.
The setting at the op-
erating mode selec-
tor was changed.
The clocks have
changed to summer/
wintertime.
The elements at The elements at the
the very top and top have not com-
bottom don't get as pletely filled.
warm as the rest of
the appliance.
Dirty marks appear Dirty marks are
on the wall around caused by contam-
the appliance. inated air from the
interior (candles, cig-
arette smoke, poor
ventilation etc.).
tractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
The type plate is located underneath the appliance on
the right hand side.
Remedy
The smell will dissipate
within a few minutes.
Replace the fuse/reset the
MCB.
Remedy the cause of the
draught.
Set the required room
temperature at the temper-
ature selector.
Disconnect the appliance
from the power supply
for 10 minutes and then
switch it back on. If the
problem occurs regularly,
arrange for your power
supply utility to check the
power supply.
Set the 24 h automatic
function again.
Set the 24 h automatic
function again.
Set the 24 h automatic
function again.
-
pands when it gets warm.
It takes a little longer for
these elements to heat up.
Remedy the cause of any
air contamination.
-
INSTALLATION
7.
commissioning, maintenance and repair of the appliance.
7.1
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
7.2
Note
8.
8.1
2 bathrobe hooks
The appliance is delivered fully wired.
9.
9.1
WARNING Electrocution
!
!
!
socket.
Operation - Installation
-
-
-
13