Shutting Down; Safety Notes - AEG WKL 503 Gebrauchs- Und Montageanweisung

Limiting the thermostat
Using the two pins on the back of the switch housing (3), the
thermostat can be fixed in a particular setting. To fix a desired
temperature, push pin
To limit the temperature adjustment range, set the minimum and
maximum values on the selector knob and mark these by inserting
pin into the opposite, slightly offset hole each time.
b
1.2.1 External room thermostat
If necessary the unit can be operated with a commercial external
room thermostat. The temperature selector (2) must be turned to the right stop (MAX). The room ther-
mostat should be located as far as possible from the unit and at least 1.5 m high.
1.2.2

Shutting Down

To shut down the unit, move the switch to the OFF position and remove the mains plug from the wall
socket (do not pull out the plug using the lead).
1.3

Safety notes

The unit should not be operated
– in rooms at risk of explosion or fire from chemicals, dust, gas or vapour,
– in the immediate vicinity of pipes or containers which transport or contain flammable or
explosive substances,
– if the minimum distances from adjacent object surfaces are not observed.
Installation (electrical installation), first operation and maintenance of this unit may only be performed

by an accredited expert according to these instructions.
The unit must not be operated if in the same room work is performed such as floor laying, grinding, sea-

ling, cleaning with petrol and care (spray, beeswax) and similar.
The housing surfaces of the unit and the emerging air are hot during operation (over 80 °C).

Risk of burns!
Keep small children away from the unit.
Do not place objects on the unit, lean objects against it or store anything between the heater and the

wall (e.g. drying washing).
Also do not place in the immediate vicinity of the unit any flammable, combustible or heat-insulating
objects or substances such as laundry, blankets, newspapers, containers of beeswax or petrol, spray cans
or similar. Risk of explosion!
To prevent overheating of the unit, it must not be covered.
1
into the hole opposite.
a
for the professional installer
b
b
a
3
2
3